Narex Richter VS. Stanley 750 Chisels – Tool Review Tuesday

*Support What We Do at The Katz-Moses Store*
On this Tool Review Tuesday we are comparing the Narex Richter Chisels vs the Stanley 750s. As always, I have never and will never take money for paid reviews. These are tools I have purchased and used extensively. If you can think of a better name than Tuesday Tool Reviews (Not Tool Duel @mattestlea already came up with the G.O.A.T.) PLEASE let me know down in the comments. Let me know what you’d like to see next. Thanks for watching! Please like, comment and subscribe. Cheers!
*Support What We Do at The Katz-Moses Store*
*Narex Richter Chisels (all sets, gift pack and singles)*
*Stanley 750s (8 Piece)*
*Stanley 750s (4 Piece)*
*Canvas Chisel Roll I use and like (only $9.99)*
*Narex Angled/Skew Chisels I mentioned and like for getting in super tight dovetail corners*
Buy the Katz-Moses Magnetic Dovetail Jig:
Taytools is my favorite woodworking tool source:
I have Walnut Slabs for sale:
Buy the Katz-Moses Stop Block :
BitsBits is the BEST place to buy router bits: USE CODE JKATZMOSES15 for 15% off
Total Boat Epoxy: 10% Discount code JKATZMO
Essential Woodworking Skills Playlist:
Woodworking Routers Video Playlist:
Woodworking Joint of the Week Playlist:
Woodworking in SLOW MOTION Playlist:

50 Free Woodworking Plans

Tool Tune Up Thursday Playlist:
Check me out on social media:
Tools I love:
My Apron:
My favorite Dozuki dovetail saw –
My favorite Ryoba saw –
Marking Gauge:
Marking Knife:
NEW Suizan Flush Trim Saw:
Stanley Sweetheart Chisels:
Knew Concepts Fret Saw:
Dewalt Planer Package:
Forrest 10” Combo Blade:
Festool Tape Measure:
Starrett 6” Combination Square:
Woodstock 3 in 1 Shoulder Plane:
Stanley Low Angle Jack Plane:
Dewaxed Shellac Flakes:
Abalone Inlay :
Abalone Inlay Alternate:
5 Minute Epoxy:
Triton 3 ¼ hp Router (with built in lift and edge guide incl):
Kreg Router Plate:
Triton Bushing Set:
Bosch 1 HP Colt Router Set With Fixed and Plunge Base:
Bosch Edge Guide:
Bosch Bushings Set:
Centering Cone:
MY CNC MACHINES (I highly recommend both)
Bescutter Laser’s Website:
Avid CNCs of all shapes and sizes:
Camera Gear:
Lumix GH5-s and main lens:
30mm Macro Lens:
15mm Lens:
50mm Lens I use for product shots:
Lav Microphone:
2nd CAMERA Canon 70d:
24MM Wide Angle/Macro Lens:
50MM f/1.8 for those tight shots:
10-18mm Lens for the wide shots:

Leave a Reply

Your email address will not be published. Required fields are marked *